eth0 —
wlan0 —
—
RedPitaya Network Manager
CHECKING NETWORK STATE
Network service is not responding. Check nginx and the scripts under
/opt/redpitaya/www/apps/network_manager/scripts.
Status
wlan0 is absent. No USB wireless adapter is attached; wired
networking is unaffected.
Diagnostic WiFi
Shown because something needs attention. Lines marked ! or × are the ones to act on.
| Not run yet. |
Wired — eth0
Written to /etc/systemd/network/wired.network.
Address
Lease pool
—
Offered to clients
Left empty, clients are told to route
through this board.
Left empty, the board hands out whatever
resolver it is using itself.
Wireless — wlan0
Client mode. Written to /opt/redpitaya/wpa_supplicant.conf.
wlan0 is absent. Plug a USB adapter in; these settings apply
as soon as one appears.
Radio
Left unset, every 5 GHz channel is
passive-scan only — visible in a scan, impossible to join.
Network
Scan
wlan0 is absent. Nothing to scan with.
| SSID | Security | Signal | ||
|---|---|---|---|---|
| No scan yet. | ||||
Access point
Written to /opt/redpitaya/hostapd.conf. Mutually exclusive with
client mode — starting the AP stops the supplicant.
wlan0 is absent. An access point needs an adapter that
supports AP mode.
Radio
8 to 63 characters, or empty for an
open network.
Taken from the wireless section;
written as country_code with ieee80211d=1.
Network
Lease pool
—
Left empty, clients are given this board as
their resolver.
| Address | MAC | Signal | Connected | Rx | Tx |
|---|---|---|---|---|---|
| No stations. | |||||